. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER HM METHOD OF USING ACCURATELY 6 - 5 1. LENGTH OF SUSPENSIO The payload meter uses the signal from the suspension pressu re sensor to measure t he loa d. Adjust th e length of t he suspension cylinde r periodically to the proper range. For details, please consul t your Komatsu dis tributor. 2. CARRYING OUT CALIBR ATION el in the following cases. s been brought into the jobsite s been modified (when the machine weight has changed) cylinder gas has been adjusted ic interval has passed travel on a flat, straight road of approx. 120 m (393 ft 8 in) with no uneven places.
Carry out calibration trav When the machine ha When the machine ha s been modified (when the machine When the suspension cylinder gas has been adjusted ic interval has passed When the fixed period Carry out the calibration travel on a flat, straight road of appro x. 120 m (393 ft 8 in) with no uneven pla If t he measurement is ca rried out on a road that is not flat or not straight, it will be impossible to achieve a ccurate measurement. 3. METHOD USING TRAVEL MODE el mode is selected When method using trav The accuracy varies a as possible.
This wi measurements, carry The accuracy varies accurate the measure 8 km/h (5.0 MPH) and distance is 100 m (32 When method using trav The accuracy varies a ccording to the condition of the road. Carry out the calibration on a roa d that i s as flat as possible. This wi ll make it possible to carry out acc urate measurement. To make highly precise first. . The longer the distance travelled, the more precise measurements, carry out maintenance of the road surface The accuracy varies according to the distance travelled accurate the measure ment becomes. Carry out the measu rement only when traveling a t a speed of at least 8 km/h (5.0 MPH) and on a grade of less than 5°.
Even on r oads fulfilling the abov e conditions , the m inimum distance is 100 m (32 8 ft 1 in). 4. METHOD USING DUMPIN G MODE ping mode is selected ing range is flat area a place where the grade is within ±5°. If the grade is more than ±5°, the accuracy will in strong contact with the tires. If there is strong contact, the payload measurement an the actual value. he parking brake. Release the foot brake or retarder brake. nd wait for the pitching of the machine to stop before raising the dump body. When method using dum Carry out where work Carry out the work in be poor.
Do not put the blocks value will be higher th When dumping, use t Stop with the brake a To obtain an accurate for 3 to 5 seconds be When method using dum Carry out where work Carry out the work in a place where the grade is within ±5°. If the grade is more t han ± be poor. Do not put the blocks value will be higher th When dumping, use t he parking brake. Release the foot b rake or retarder brake Stop with the brake a nd wait for the pitching of the machin e to stop before raisin g the d ump To obtain an accurate value, apply the parking brake and re lease the foot brake or retard er brake. Th en wait for 3 to 5 seconds be fore dumping. accur acy will he pa yload measurement