13. TRANSPORTATION 13.4 PRECAUTIONS FOR TRANSPORTATION WARNING Determine the route for transporting the machine by taking into account the width, height and weight of the machine. Obey all state and local laws governing the weight, width and length of a load. Observe all regulations governing wide loads. 13.5 REMOVAL OF CAB (MACHINES EQUIPPED WITH CAB) If it is necessary to remove the cab for transportation, disconnect the washer hoses, and cab power source and washer motor wiring from the socket before removing the cab. 1. Pull the grommet portion in towards the cab from the hole in the machine cover, then remove. 2.
Disconnect 4 washer hoses and the wiring (single wires x 2, 4- pin plug x 1) from the socket. REMARK After removing, cover the washer hoses with a vinyl bag to prevent any dirt or dust from entering. Before removing the cab, measure the clearance between the cab and each lever (joystick and blade control lever, etc.). Note the measurements to use as a standard when installing the cab again. 2-77