. OPERATION TRANSPORTATION LIFTING MACHINE WARNING NOTICE options actually installed on the machine. For the proper lifting 3 - 125 The operator carrying o ut the lifting operation using a c rane must be a properly qualified crane ope Never raise the machine Always make sure that t he wire rope is of ample strengt h for the weight of this Never lift the machine wi th the upper structure swung to the side . Alway s set the upper structure pa rallel to the undercarriage before lifting. achine horizontal. hine when it is raised.
When lifting, keep the m Never go under the mac Never try to lift the mach ine in any posture other than the posture given i n the procedure below or usi ng lifting equipment other than in the procedure be low. e machine may lose its balance. There is a hazard that th e machine may lose its balance The lifting procedure appli es to machines with standard sp The method of lifting diffe procedures, contact your K For details of the weight , see "SPECIFICATIONS (P AGE 5-2)". follows. rk equipment is at the rear of the machine. When lifting the machin e, carry out the operation on flat ground as follows 1. Start the engine, then swing the upper structure so that the wo 2.
Extend the bucket cylinder and arm cylinder fully, then lower the work equipment to the ground as shown in the diagram on the right using the boom cylinder. 1. Start the engine, the n swing the upper structure so that the wo rk equipment is at the re 2. Extend the bucket c ylinder and arm cylinder full y, then lower the work equipment to the ground as shown in th e diagram on the right using the b 3. Set the lock lever se curely to the LOCK position 4. Stop the engine, ch eck that there is nothing arou nd the operat or's compartment, then g Close the cab door and front glass securely.