OPERATOR'S STATION Station Presetting Procedure 1. Select the desired station using tuning switches (5). (Refer to the “Tuning Procedure” section.) 4 7 2. Press and hold one station preset (4) for more than 1 sec- ond until an electronic tone is heard. Now, the selected station is preset for the selected station preset. The fre- quency of the preset station will be indicated on digital display (7). Once the presetting is complete for a station preset (4), the radio will be tuned to the preset station when station preset (4) is pressed (for less than 1 second). 5 M1G6-01-026 DIGITAL CLOCK SETTING PROCEDURE NOTE: In order to set the clock, digital display (7) must be in the time display mode.
1. Press display mode button (6) to indicate the hour dis- play on digital display (7). 7 2. Press and hold time set button (RST) (8) for longer than 1 second. The hour display will start flashing and the time set mode will be selected. 3. Press time set button (H or M) (8) to set the clock. Each time time set button (H or M) (8) is pressed, the time dis- play will increase by one. If time set button (H or M) (8) is pressed and held, the time display will change continu- ously. 6 8 M1G6-01-026 • When setting the hour, pres time set button (H) (8). • When setting the minute, press time set button (M) (8). The time is displayed in 12 hour standard.
If either of the switches (H) or (M) is pressed and held, the hour or minute display will change continuously until the switch is released. 4. When the hour display is “12,” if time set button (H) (8) is pressed, the hour display will be reset to “1.” When the minute display is “59,” if time set button (M)(8) is pressed, the minute display will be reset to “00.” However, the hour display remains unchanged in this case. 5. After the clock setting is complete, press and hold time set button (RST)(8) again for longer than 1 second, or turn the radio switch OFF to end the clock time setting procedure. Digital display (7) stops flashing and changes to stay ON. 1-70