Yamaha Motor Corporation, USA 115TR — Maintenance

Maintenance to slowly break down and erode. If electrode erosion becomes excessive, or if carbon and other deposits are excessive, you should re- place the spark plug with another of the cor- rect type. 1. Remove the spark plug caps from the spark plugs. 2. Remove the spark plug. If electrode ero- sion becomes excessive, or if carbon and other deposits are excessive, you should replace the spark plug with an- other of the correct type. WARNING! When removing or installing a spark plug, be careful not to damage the in- sulator. A damaged insulator could allow external sparks, which could lead to explosion or fire. [EWM00561] Spark plug gap: 0.9–1.0 mm (0.035–0.039 in) 4.

When fitting the plug, wipe off any dirt from the threads, and then screw it in to the correct torque. Spark plug torque: 25.0 Nm (2.55 kgf-m, 18.4 ft-lb) TIP: If a torque-wrench is not available when you are fitting a spark plug, a good estimate of the correct torque is 1/4 to 1/2 a turn past fin- ger-tight. Have the spark plug adjusted to the correct torque as soon as possible with a torque-wrench. Standard spark plug: BR8HS-10 EMU37450 Checking fuel filter Check the fuel filter periodically. If any water or foreign matter is found in the filter, clean or replace it. For cleaning or replacement of the fuel filter, consult your Yamaha dealer. 3.

Be sure to use the specified spark plug, otherwise the engine may not operate properly. Before fitting the spark plug, measure the electrode gap with a wire thickness gauge; adjust the gap to spec- ification if necessary. ZMU04151 EMU29041 Inspecting idling speed EWM00451 WARNING 1. Spark plug gap 2. Spark plug I.D. mark (NGK) 3. Spark plug part number Do not touch or remove electrical parts when starting or during operation. Keep hands, hair, and clothes away from the flywheel and other rotating 62