Maintenance parts while the engine is running. ECM00490 NOTICE This procedure must be performed while the outboard motor is in the water. A flushing attachment or test tank can be used. A diagnostic tachometer should be used for this procedure. Results may vary depending on whether testing is conducted with the flushing attachment, in a test tank, or with the outboard motor in the water. 1. Start the engine and allow it to warm up fully in neutral until it is running smooth- ly. TIP: Correct idling speed inspection is only possi- ble if the engine is fully warmed up. If not warmed up fully, the idle speed will measure higher than normal.
If you have difficulty ver- ifying the idle speed, or the idle speed re- quires adjustment, consult a Yamaha dealer or other qualified mechanic. 2. Verify whether the idle speed is set to specification. For idle speed specifica- tions, see page 13. 1. Water trap 2. Engine oil tank EMU29112 Checking wiring and connectors Check that each grounding wire is properly secured. Check that each connector is engaged se- curely. EMU29050 Checking water in engine oil tank Oil injection models There is a water trap at the bottom of the en- gine oil tank. If water or foreign matter is vis- ible in this trap, consult your Yamaha dealer.
EMU32111 Checking propeller EWM01880 You could be seriously injured if the en- gine accidentally starts when you are near the propeller. WARNING Before inspecting, removing, or install- ing the propeller, place the shift control in neutral, turn the main switch to “ (off) and remove the key, and remove the clip from the engine shut-off switch. 63 2 1 ZMU01895 ZM U0