Yamaha Motor Corporation, USA 115TR — Maintenance

Maintenance been drained. If the oil is milky, water is getting into the gear case which can cause gear damage. Consult a Yamaha dealer for repair of the lower unit seals. [ECM00711] TIP: For disposal of used oil, consult your Yamaha dealer. 5. Put the outboard motor in a vertical po- sition. Using a flexible or pressurized fill- ing device, inject the gear oil into the gear oil drain screw hole. EMU29312 Inspecting and replacing anode(s) Yamaha outboard motors are protected from corrosion by sacrificial anodes. Inspect the external anodes periodically. Remove scales from the surfaces of the anodes. Consult a Yamaha dealer for replacement of external anodes.

ECM00720 NOTICE Do not paint anodes, as this would render them ineffective. Recommended gear oil: Hypoid gear oil SAE#90 Gear oil quantity: 0.760 L (0.803 US qt, 0.669 Imp.qt) TIP: Inspect ground leads attached to external anodes on equipped models. Consult a Yamaha dealer for inspection and replace- ment of internal anodes attached to the pow- er unit. ZMU03274 ZMU01901 6. Put a new gasket on the oil level plug. When the oil begins to flow out of the oil level plug hole, insert and tighten the oil level plug. Tightening torque: 9 Nm (0.9 kgf-m, 6.6 ft-lb) 7. Put a new gasket on the gear oil drain screw. Insert and tighten the gear oil drain screw. ZMU03461 Tightening torque:

9 Nm (0.9 kgf-m, 6.6 ft-lb) 66