OM6007 2/99 Optional Equipment - Section 6 Payload Meter II Page 6-17 SETUP AND MAINTENANCE 7. Press the LIGHT/INC switch to change the ‘‘tens digit’’ to the desired number. 8.Press the MODE switch to return to normal opera- tion. Speed Limit A warning can be displayed if the machine exceeds a preset speed. 9. The Option Code selects the PLM communication mode as follows: The available range is: 10 - 99 km/h (6 - 62 mph). It is recommended to set the speed limit to 99 km/h (62 mph). Setting The Speed Limit 1. Press and hold the MODE switch until "Cd:dP" is flashing. 2. Press the MODE switch once. The display will show: NOTES: 3. Press the MODE switch once. The display will show: 1.
The Option Code is set to ‘‘0" for trucks not equipped with Modular Mining System (MMS) (Except 530M). 4. Press the MODE switch repeatedly until "SP.XX" is displayed. 2. The 530M with Powertrain Management Control (PMC) system uses ‘‘10" as the setting for the Option Code. 5. Press the LIGHT/INC switch to change the ‘‘unit digit’’ to the desired number. 3. For trucks with Modular Mining System (MMS) or Scoreboard, the Option Code is ‘‘12". 6. Press the TOTAL/SFT switch and the display will then indicate: Setting The Machine I.D. Code 7. Press the LIGHT/INC switch to change the ‘‘tens digit’’ to the desired number. 1. Press and hold the MODE switch until "Cd:dP" is displayed.
8.Press the MODE switch to return to normal opera- tion. 2. Press the MODE switch once. The display will show: Setting the Option Code 1. Press and hold the MODE switch until "Cd:dP" is displayed. 3. Press the MODE switch once. The display will show: 4. Press the MODE switch once. "d.XXX" is displayed. 2. Press the MODE switch once. The display will show: 5. Press the LIGHT/INC switch to change the last digit to the desired number. 3. Press the MODE switch once. The display will show: 6. Press the TOTAL/SFT switch and the display will show: 4. Press the MODE switch repeatedly until "OP.XX" is displayed. 7. Press the LIGHT/INC switch to change the middle digit to the desired number. 5.
Press the LIGHT/INC switch to change the ‘‘unit digit’’ to the desired number. 8. Press the TOTAL/SFT switch and the display will show: 6. Press the TOTAL/SFT switch and the display will then indicate: Option Code COMMUNICATION MODE 0 Stand Alone 10 PMC Mode (530M only) 12 Modular Mining Mode, Scoreboard and User Data Commmunication Mode