Optional Equipment - Section 6 OM6007 2/99 Page 6-18 Payload Meter II 9. Press the LIGHT/INC switch to change the first digit to the desired number. 7. Press the LIGHT/INC switch to change the hours. The clock is a 24 hour clock. 10. Press the MODE switch to return to normal op- eration. 8. Press the TOTAL/SFT switch and the display will then indicate: Setting The Operator I.D. Code 9. Press the LIGHT/INC switch to change the day. 1. Press and hold the MODE switch until "Cd:dP" is displayed. 10. Press the TOTAL/SFT switch and the display will then indicate: 2. Press the MODE switch once. The display will show: 11. Press the LIGHT/INC switch to change the month. 12.
Press the TOTAL/SFT switch and the display will then indicate: 3. Press the MODE switch once. The display will show: 13. Press the LIGHT/INC switch to change the year. 4. Press the MODE switch repeatedly until "o.XXX" is displayed. 14.Press the MODE switch to return to normal opera- tion. 5. Press the LIGHT/INC switch to change the last digit to the desired number. DOWNLOAD OF INFORMATION 6. Press the TOTAL/SFT switch and the display will then indicate: Payload information and fault codes recorded should be downloaded to a personal computer on a regular basis. The software required is available under part number AK4094.
Detailed instructions for installing the software and downloading the data is provided with AK4094 PLM II download software. 7. Press the LIGHT/INC switch to change the middle digit to the desired number. 8. Press the TOTAL/SFT switch and the display will show: Data All Clear This function will erase all of the cycle data, engine ON/OFF data, and fault/warning data. Total payload and the overall number of cycles will not be cleared. 9. Press the LIGHT/INC switch to change the first digit to the desired number. 10. Press the MODE switch to return to normal op- eration. IMPORTANT - Before clearing the data, download the data to a personal computer.
Setting The Time and Date To begin, the shift lever should be in the ‘‘N’’ position, the brake lock set, the hoist control lever should be in the ‘‘FLOAT’’ position and the body in the down position. 1. Press and hold the MODE switch until "Cd:dP" is displayed. 1. Press and hold the MODE switch until "Cd:dP" is displayed. 2. Press the MODE switch once. The display will show: 3. Press the MODE switch once. The display will show: 2. Press the MODE switch once. The display will show: 4. Press the MODE switch repeatedly until "XX:XX" is displayed. 3. Press and hold the CAL/CLR switch until "A.CLE" is flashing. 5. Press the LIGHT/INC switch to change the min- utes. 4.
Press the CAL/CLR switch again and the memory will be cleared. The meter will then return to normal operation. 6. Press the TOTAL/SFT switch and the display will then indicate: This does not clear the Operator Load Counter.