Maintenance - Section 4 OM4006.1 06/98 Page 4-8 Lubrication and Service 1000 HOUR SERVICE Truck Serial Number ____________________________ Site Unit Number ______________________________ Date:______________Hour Meter_________________ Serviceperson Name___________________________ In addition to the 250 and 500 hour lubrication and inspection schedules, perform the following: 1. LUBRICATING - Transmission mount - 1 point. - Lube key ‘‘D’’. - Parking brake linkage - 6 point - Lube key ‘‘D’’. 2. TRANSMISSION CASE Drain oil, remove and replace element. Remove clean, and reinstall strainer. Refill tank with oil approximate 40.5 gal (153 l).
Refer to ‘‘Lubrication Chart’’ for fuel, coolant and lubricants and type of oil to use. Lube key ‘‘C’’. 3. STEERING, BRAKE, HOIST, and REAR BRAKE COOLING OIL FILTERS. When removing tank caps, turn cap slowly at first to relieve inner pressure. Remove cap only after pressure has been completely relieved. Any operating fluid, such as hydraulic oil or brake fluid escaping under pressure, can have sufficient force to enter a person’s body by penetrating the skin. Serious injury and possibly death may result if proper medical treatment by a physician familiar with this injury is not received immediately. Remove & replace (4) filter elements. Refer to ‘‘Hydraulic Tank Service’’, page 4-10 . 4.
FRONT & REAR BRAKE WEAR - Refer to shop manual Section ‘‘J’’, Brake System, for proper inspection procedure. Carry out inspection when the oil temperature is below 60°C (140°F ). Hot oil may cause serious personal injury. COMMENTS √’d INITIALS