4.8 Service procedure Every 100 hours service Maintenance Check oil level in hydraulic tank, add oil z The parts and oil are at high temperature after the engine is stopped, and may cause burns. Wait for the temperature to go down before starting the work. z When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it. 1. Lower the bucket horizontally to the ground and stop the engine. Wait for 5 minutes, then check sight gauge (G). The oil level should be between the H and L marks. 1 2 F NOTE Do not add oil above the H line. This will damage the hydraulic circuit or cause the oil to spurt out.
If oil has been added to above the H level, stop the engine and wait for the hydraulic oil to cool down, then drain the excess oil from drain plug (P). 2. If the oil is below the L level, add oil to the hydraulic tank as follows. Ѓ Remove cover (1). P G Ѓ Keep lock pin (2) pulled, then turn oil filler cap (F) coun- terclockwise and remove it. GK020029 Ѓ Refill the specified quantity of oil through oil filler (F). Ѓ After adding oil, install oil filler cap (F) and cover (1). Proper range GK032267 4-42 WA150-5H – VEAM934100 WARNING WARNING