OM6011 10/11 VHMS - Section 60 Page 60-3 PAYLOAD METER Download connector inside cab The payload meter interprets machine data to calcu- late payload. The system uses the following inputs: suspension pressure sensors, inclinometer, body up switch, transmission shift lever, and speed sensors. The microcomputer built into the controller uses the inputs to calculate the payload. The calculated pay- load is displayed on the character display on the Electronic Display Panel (EDP). The external display lamps also display the payload conditions. Data stored in the payload meter can be downloaded to a laptop computer using special software.
To ensure payload accuracy, set the shift lever to N, apply the brake lock, and release the retarder before dumping. Allow the machine to stabilize before dumping. If the machine is abruptly stopped at the dumping point, it will take a few moments for the pay- load display to stabilize. Dump on flat ground. When downloading, remove the connected cable. After the download is complete, restore the cable to its original position. If the cable is not put back into place, download from the ground level box cannot be done. Payload display Download connector outside cab External display lamps