VHMS - Section 60 10/11 OM6011 Page 60-4 NORMAL OPERATION DISPLAY (*1) Stopped = shift lever is in the N position and the travel speed signal is 0. (*2) For details of the standard display on the machine monitor, refer to Machine Monitor in Section 32. (*3) The machine starts off empty and is being loaded. It is necessary to wait for the load to go above approximately 15% of the rated payload and for the change in the load to stabilize when the machine is stopped. Example of payload display When the machine is stopped during loading, the service meter will not be displayed on the character display.
If it is desired to display the service meter, keep the machine monitor inspection switch pressed. The soft- ware version and service meter will be displayed in turn on the bottom line of the character display. Example of payload display when error occurs The payload at the loading point may differ slightly from the display at the dumping point. This is caused by the effect of the friction in the suspension, and is normal. Slight differences in payload from point to point do not indicate any failure in the payload meter. If an error occurs in the suspension pressure sensors or in the inclinometer sensor, it becomes impossible to calculate the payload. The display will show [-----].
Machine condition Machine monitor display External display lamps When starting switch is ON --- Illuminates for 30 seconds When empty Stopped (*1) Standard display (*2) OFF Traveling Standard display OFF During loading Stopped Payload display (*3) Payload display Traveling Standard display OFF When loaded Stopped Payload display Payload display Traveling Standard display OFF When dumping Stopped Payload display → standard display Payload display → OFF Traveling Standard display OFF