DISPLAYS AT START-UP 7. The display will show: POWER ON: This display indicates the Machine ID code where “xxx” indicates a value between 0 and 200. All external display lamps (Figure 20-2) will come on and stay on for approximately 27 seconds during the “Power-up Process”. 8. The display will show: The “Power-up Process” will display the PLM settings. Each display will occur for approximately 3 seconds: This display indicates the Operator ID code where “xxx” indicates a value between 0 and 200. 9. The display will show: 1. The display will show: In addition, a buzzer will sound and the following lamps will light for 3 seconds:
This display indicates the Speed Limit setting where “xx” indicates a value be- tween 0 and 99 km/h. Reception Pilot Lamp (2, Figure 20-1) 10. The display will show: Transmission Pilot Lamp (3, Figure 20-1) Memory Card Pilot Lamp (4, Figure 20-1) This display indicates the Option code setting. 2. The display will show: The “xx” indicates the Truck Model. Refer to "Initial Setup of Payload Meter" for code definitions. Refer to “Operator Check Mode, Setting the Op- tion Code” and to “Method of Operation” for more information on this function. 3. The display will show: This display indicates the status of the Memory Card where: “Cd : - -” indicates Card Not Used, and “Cd :
oo” indicates Card Is Used. NORMAL OPERATION 4. The display will show: This display indicates the status of the Inclinometer for the PLM, where If the truck engine is started before the preceding “Power-up Process” is completed, the display will shift to normal operation. “CL : - -” indicates Inclinometer Not Used, and “CL : oo” indicates Inclinometer Is Used. If the engine is running when the payload meter starts up, only "o:XXX" and "d:XXX" will display before switching to normal operations. 5. The display will show: This display indicates method of measurement where: "US : - -" indicates METRIC Tons. "US : oo" indicates U.S. Tons. 6. The display will show: This function is not used. "SU :
- -" indicates Switch 8 is up. "SU : oo" indicates Switch 8 is down. M20-18 Payload Meter II M20007.1 03/02