SETUP AND MAINTENANCE Setting the Option Code Speed Limit 1. Press and hold the MODE switch until "Cd:dP" is displayed. A warning can be displayed if the machine exceeds a preset speed. 2. Press the MODE switch once. The display will show: The available range is: 10 - 99 km/h (6 - 62 mph). It is recommended to set the speed limit to 99 km/h (62 mph). 3. Press the MODE switch once. The display will show: Setting The Speed Limit 4. Press the MODE switch repeatedly until "OP.XX" is displayed. 1. Press and hold the MODE switch until "Cd:dP" is flashing. 2. Press the MODE switch once. The display will show: 5. Press the LIGHT/INC switch to change the “unit digit” to the desired number. 3.
Press the MODE switch once. The display will show: 6. Press the TOTAL/SFT switch and the display will then indicate: 7. Press the LIGHT/INC switch to change the “tens digit” to the desired number. 4. Press the MODE switch repeatedly until "SP.XX" is displayed. 8.Press the MODE switch to return to normal opera- tion. 5. Press the LIGHT/INC switch to change the “unit digit” to the desired number. 9. The Option Code selects the PLM communication mode as follows: 6. Press the TOTAL/SFT switch and the display will then indicate: 7. Press the LIGHT/INC switch to change the “tens digit” to the desired number. 8.Press MODE switch to return to normal operation. NOTES: 1.
The Option Code is set to “0" for trucks not equipped with Modular Mining System (MMS) (Except 530M/HD1500). 2. The 530M/HD1500 with Powertrain Management Control (PMC) system uses “10" as the setting for the Option Code. 3. For trucks with Modular Mining System (MMS) or Scoreboard, the Option Code is “12". M20007.1 03/02 Payload Meter II M20-19 Option Code COMMUNICATION MODE 0 Stand Alone 10 PMC Mode (530M/HD1500 only) 12 Modular Mining Mode, Scoreboard and User Data Commmunication Mode