Doosan D90S-5 — Doosan D90S-5 User Manual

Maintenance Section Transmission Oil Level – Check 4. Shift the transmission into NEUTRAL. Engage the parking brake. Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. 5. Loosen the oil dipstick counter-clockwise, remove and clear it. Insert the oil dipstick slowly into the oil level tube until contact is obtained, and pull the dipstick out again. 6. When the oil temperature is around 40°C, the marking on the oil dipstick must be lying above the cold start mark, "COLD". When the oil temperature is around 80°C, the oil level must be lying in the zone "HOT". 7. Install the oil dipstick again and tighten it clockwise. 8.

Check for oil leaks at the filter and drain plug. 9. Stop the engine. 1. Start and operate the lift truck until the transmission reaches normal operating temperature (about 80°C). 2. Park the lift truck level with the forks lowered, parking brake applied and the transmission controls in NEUTRAL. 3. With the service brake applied and the engine at low idle, shift the directional control lever to forward and then to reverse, to fill the clutches. Typical Example D50/60/70/80/90S-5 (3 Speed) Typical Example D50/60/70S-5 (2 Speed), G50/60/70S-5 151 WARNING