Doosan D90S-5 — Doosan D90S-5 User Manual

Maintenance Section First 50-100 Service Hours or a Week You must read and understand the warnings and instructions contained in the Safety section of this manual, before performing any operation or maintenance procedures. Engine Oil & Oil Filter (Diesel E/G Only) - Change The percentage of sulfur in the fuel will affect the engine oil recommendations. If the fuel has over 0.5% sulfur content, the engine oil must have a TBN of 20 times the percentage of fuel sulfur (TBN as measured by the ASTM D-2896 method). Your oil supplier should be able to furnish the correct oils. 1. Operate lift truck a few minutes to warm oil.

Park the lift truck with the forks lowered, parking brake applied, transmission in neutral and the engine stopped. 2. Raise rear of lift truck off the ground and block securely. NOTICE Careless disposal of waste oil can harm the environment and can be dangerous to persons. Always dispose of waste oil to authorized and licensed personnel only. 3. Remove the crankcase drain plug and allow oil to drain. Clean and install drain plug. 4. Raise the left side cover. 5. Remove and discard oil filter element. 6. Wipe sealing surface of oil filter element mounting base. Make sure all of the old gasket is removed. 7.

Before installing a new filter element, apply a small amount of clean engine oil to the filter element gasket. 8. Install the new filter element. When the gasket contacts the base, tighten it 3/4 of a turn more. Do not overtighten. 9. Raise the lift truck, remove the blocking and lower the lift truck. Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. Typical Example Diesel Engine Truck 152 WARNING