www.changlin.com.cn If required, loosen the compressor housing position the housing to align with the air crossover tube. 11 mm. Plastic Hammer Tighten the band clamp. Tap around the clamp with plastic hammer and tighten again. Torque Value: 8N*m [71 in-lb] NOTE: Effective Oct. 1,1990 all holset Turbochargers use silver plated nuts with the v-band clamp. The silver plated nuts require a lower torque than the stainless steel nut to provide the same v-band clamp load. Caution: New turbochargers must be prelubricated before start-up to prevent internal damage. Pour 50 to 60 cc [2 to 3 ounces] of clean 15W-40 engine lubricating oil into the oil supply fitting.
Rotate the turbine wheel to allow the lubricating oil to enter the bearing housing. 126 / 149 pages 1 mm. Punch, Hammer loosened, tighten the turbine housing capscrews. orque Value: 11 N*m [100 in-lb] 1 mm