www.changlin.com.cn Install the exhaust outlet connection. Do not tighten the two mounting capscrews until the band clamp has been tightened. Torque Value: Band Clamp - 8N • m [70 in-lb] Capscrews - 43N • m [32 ft-lb] 16 mm Install the lubricating oil supply line. Torque Value: 35N • m [26 ft-lb] WARNING: The oil supply line must not contact turbine housing. The line can burn, causing equipment damage, and severe personal injury. Install the air inlet and exhaust piping. Install the wastegate actuator line. Operate the engine and check for leaks. Exhaust Manifold and Gaskets Replacement Preparatory step: Remove the air crossover tube. Disconnect the air intake and exhaust piping.
Remove the turbocharger, if used. 127 / 149 pages