OM2017.2 Safety - Section 2 Warnings and Cautions Page 2-25 A WARNING plate is located near the “HOT START” connection which is attached to the back side of the front bumper on the left side of the truck. This warning plate states that the engine should not be started while the optional “HOT START” is in operation. Operators should observe this area during “Ground Level Inspec- tion” and be certain that this option is disconnected from the truck before starting engine. A decal is attached to the frame rail near the hoist cylinder creep down valve which is located on the hydraulic tank.
This decal states that the body may be lowered in a controlled manner by opening the valve and allowing the hoist cylinders to slowly retract. A DANGER plate is attached to or near the steering accumulator mounting bracket. This plate alerts technicians to read the warning label attached to the top of the steering accumulator prior to releasing internal nitrogen pressure or disconnecting any hydraulic lines or hardware. A DANGER plate is attached to each suspension cylinder and steering accumulator. The plate contains instructions for releasing internal pressure prior to disconnecting any hydraulic lines or hardware.