Control locations and functions Ignition switch The ignition switch has three posi- tions: !! CAUTION !! Leaving the ignition switch in the LIGHTS position for a long peri- od of time when the engine is not running may cause the battery to discharge. Always leave the igniti- on switch in the OFF position when engine is not running. Speedometer/Indicator Lights 1. Speedometer: The speedometer shows approxi- mate speed. OFF -Position: All electrical circuits except the accessory plug are off. The engine will not start. The key can be removed in this position. 2. Odometer: The odometer shows the total distance travelled. q NOTE The accessory plug is powered by the battery at all times.
Lights Position (level 2): The igniti- on circuit is complete and the head- lights and taillight are on. The key cannot be removed in this position. 3. Trip Meter: The trip meter is an odometer which can be reset. It can be used to show the distance travelled on short trips or between gas stops. ON -Position (level 1): The ignition circuit is complete and the engine can run. The key cannot be remo- ved in this position. The sidelight is on. Only 700 Diesel: Preheating. · 700 Diesel Control Page 24