4. High Beam Indicator: A blue light will illuminate when the lights are on high beam. The light will not be illuminated when the lights are switched to low beam. q NOTE High engine RPM, low vehicle speed or heavy load can raise engi- ne temperature. Decreasing engine RPM, reducing load and selecting an appropriate transmission gear can lower the temperature. 7. Reverse Indicator: An orange light will illuminate when the re- verse gear is engaged. (500/650) !! CAUTION !! A continuous use of the ATV with low oil pressure can cause engine damage or a premature wear of the engine. 5. Temperature Indicator: A red light will illuminate if the engine overheats (400/500/650 H1).
q NOTE Debris in front of the engine or pa- cked between the oil cooler/radiator cooling fi ns can reduce cooling capability. Clean the engine and oil cooler/radiator to remove any debris preventing air fl ow. 700 Diesel: The complete display extinguishes and only the „F“- lamp will fl ash. !! WARNING !! A continuous use of the ATV with high oil temperature can cause en- gine damage or a premature wear of the engine. 6. Neutral Indicator: The „N“ indi- cator light will illuminate when the transmission is in neutral and the ignition switch is on. The light will go out when shifted into any gear other than neutral. Page 25