. OPERATION OPERATION CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL WARNING at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil 3 - 105 Parts and oil are temperature to go 1. Open the e ngine side cover on the left side of the c 2. 3. 4. ( I ( 5. I 6. I 2. Remove dip stick (G), and wipe the oil off with a clot h. it. on dipstick il filler port ne oil from curely and 3. Fully insert dipstick (G) into filler pipe, then remove 4. The oil level should be between the H and L marks G). f the oil lev el is below the L mark, add oil through o F). 5.
I f the oil is a bove the H mark, drain the excess engi drain plug ( P), and check the oil level again. el is correct, tighten the oil filler cap se gine side cover. 6. I f the oil lev close the en REMARK l level with the engine stopped. Check the oi When checki ng the oil level immediately after stoppin g the engine, wait for at least 15 minutes after stoppin g the engine befor e starting the inspection operation. before starting inspection. to remove the air inside the crankcase. If the machin e is at an angle, set it in a level position When addin g oil, remove the dipstick from the guide to remove the air inside the crankcase.