Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION REMARK When checking the oil level with the engine stopped before HOT IDLE. REMARK When inspecting, if the machine is at an angle, move it to a level place to carry out the check. 3 - 106 CHECK OIL LEVEL IN POWER T 1. Remove dipstick (G), and wi 2. Fully insert dipstick (G) into 3. Check that the oil level is dipstick (G). If the oil level is below the L The dipstick has two sides mark, add oil through oil filler (F). for checking the oil level: COLD engine is stopped and the oil STOP for use when the temperature is low; and HOT IDLE for use when the engine is idling and the oil temperatur starting operations, check the oil level with the side marked COLD STOP.

It is also possible to che ck the oil level even after starting operations when the power train but in this case, run the engine at idling and use the side marked 4. When hydraulic oil is above t he H level, remove drain cover (1) on the left side of the power train case bottom, take out drain plug (2), drain excess oil by loosening drain plug (3) and then check the oil level again. ten the oil filter cap securely. 5. If the oil level is correct, tigh