Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL WARNING 6 ° . Lower ripper (b) on the ground vertically so that the pin is at the lowest position. 3 - 108 When removi ng the oil filler ca p, oil may s purt o ut, so stop the engine and w ait for t he oil t emperature to g o down , then turn the ca p slowly to releas e the in ternal pressure be fore removing th e cap If oil h as bee n adde d to above t he H mark, stop t he engine a nd wait for the hy draulic oil to c ool down. T hen remove drain plug (P), lo osen drain valve ( 1), and drain the excess 1.

Park the m achin e o n the fl at ground, hold it in the fo llowing posture suitable for an oil check and then st op the engi (Sigmadozer) Lower th e blad e on the ground so that a ngle ( a) of its b ackside is Item Dimension Item Dimension Blade (DUAL) Tilt Cylinder length 1,292mm (50.9in) Tilt Cylinder Blade (SINGLE) Brace 1,292mm length (50.9in) 1,292mm (50.9in) Ripper (VGR,VMR) Lift Cylinder length 1,543mm (60.8in) Lift Cylinder Ripper (VGR,VMR) Tilt Cylinder 1,543mm length (60.8in) Tilt Cylinder length 1,607mm (63.3in) 1,607mm length (63.3in)