. OPERATION OPERATION (H) Adjusting headrest height Move the headrest up or down and set to the desired height. Amount of adjustment: 100 mm (3.9 in) region. 3 - 116 (E) Fore-and-aft adjustm Operate lever (4) up, set the seat cushion to the desired positio n, then release Fore-and-aft adjustment: (F) Adjusting reclining an gle move the back cushion to the front or rear. Operate lever (5) up and move the back cushion to the f ront or But your back firmly again st the seat back when carrying out thi s adjustment. If you move your bac k away fro m the seat back, the seat back may suddenly spring forward. over 20 degrees is free) Amount of adjustment Forward tilt: 20 degrees ( Rear tilt:
60 degrees NOTICE If the seat back is reclined to o far, the seat back may hit the rear glass, so use it in a positi on where it does not contact the glass. (G) Adjusting headrest a Rotate the backrest to th e front or rear and set to the desired a Amount of adjustment: 3 (I) Lumbar support Operate switch (6) to giv e suitable tension to the lumbar Adjust the curve of the ba ckrest portion as desired. es stronger es weaker Push (+): Tension becom Push (-): Tension becom (J) Adjusting hardness of suspension damper It is possible to adjust the hardness of the suspension damper w knob (7).
If knob (7) face s the front of the seat (a), the suspensi becomes harder; if it face s the rear of the seat (b), the suspensi becomes softer. stages Amount of adjustment: 5