. OPERATION OPERATION Machines equipped with air suspension seat Fore-and-aft adjustment: 190 mm (10 mm x 19 stages) Rear tilt: 11 degrees 3 - 115 Adjustments (C), (D), a nd (K) use the air compressor b uilt into the seat, so turn th e engine starting s witch to the ON position. NOTICE There is danger of damag e to the air compressor, so do not k eep lever (3) operated continuously for more tha (A) Fore-and-aft adjust ment Pull lever (1) up, set th the lever. e seat to the desired position, then release (B) Adjusting seat angl e Move lever (2) up, mo ve the seat cushion at the front up or down to set to the desired po Amount of adjustment Forward tilt:
3 degrees (C) Adjusting seat hei ght tment uses an air system, and it can be ight, pull lever (3) up fully or push it down The seat height adjus adjusted steplessly. When adjusting the he fully (when pulling it up , pull it until a click is felt). When the seat is set at the desired hei ght, release the lever. If the le ver is kept pulled up, the position where the seat does not rise an y further is the maximum height. When the seat reaches the maxim um height, the suspension autom atically goes down slightly to secure the f the lever.
amount of movement o If the operator raises hi s body from the seat or changes t he amount of weight applied to t he seat during adjustment, the air in the charged. 80 mm (3.2 in) suspension may be dis Amount of adjustment: (D) Setting seat for we ight To protect the operator , it is necessary to adjust the sus pension to match t he operator's weight. W hen carrying out this adjustment, stop t he machine, set the seat to the c orrect posture, the n opera te the lever. Pull up lever (3) lightly a short distance. The weight se tting is adjusted au tomatically. (The air pre ssure inside the suspension is increase d or decreased to match the op erator's weight.)