. OPERATION LONG-TERM STORAGE LONG-TERM STORAGE DURING STORAGE WARNING ventilation and prevent gas poisoning. AFTER STORAGE 3 - 186 BEFORE STORAGE long time (more than one month), do as follows. When putting the machine in storage for a long time (more than one month), do as follows. Clean and wash all parts, then store the machine indoors. If the machine has to be store d outdoors, sel ect level ground and cover the machine with can vas. nts moisture from collecting. rage. face of the hydraulic piston rods and the idler adjusting rods. the battery and cover it, or remove it from the machine and store it Completely fill the fuel tank.
This preve Lubricate and change the oil before sto Apply a thin coat of grease to metal sur face of the hydraulic piston rods and the idler adjustin Disconnect the negative terminals of separately. Place all control levers at the neutral po sition, set the work equipment lock lever and parking brake lev er to the lock position, and set the fuel control di al to the low idling position. To prevent rust, fill with Komatsu genuin e supercoolant (AF-NAC) to give a density of at le ast 3 0% for th e engine coolant.
If it is necessary to perform the rust-prevention operation while the machine is indoors, open the doors and windows to improve During storage, operate and move the m achine for a short distance once a month so that a new film of oil will coat moving parts. At the same time, also c harge the battery. ditioner, run the air conditioner. For machines equipped with an air con NOTICE If the machine has been stored without carryin g out the monthly rust-prevention operation, consult your Komatsu d istributor before using it. When using the machine after long-term s torage, do as follows before using it. cylinder rods. nts.
Wipe off the grease from the hydraulic Add oil and grease at all lubrication poi When the machine is stored for a long pe riod, moisture in the air will mix with the oil. Check the oil before and after starting the engine. If there is water in the oil, change all the oil. STARTING MACHINE AFTER LON G-TERM STORAGE When starting the engine after the machine has been in storage for a long period, carry out the warming-up o peration thoroughly. For details, see the procedur e in "WARMING UP OPERATIONS (PAGE 3-129)".