Komatsu — AFTER RUNNING OUT OF FUEL

. OPERATION TROUBLESHOOTING TROUBLESHOOTING AFTER RUNNING OUT OF FUEL PROCEDURE FOR BLEEDING AIR CAUTION NOTICE 3 - 187 When starting the engine again after running o ut of fuel, fill with fu el, then bleed the air from the fuel system b efore starting the engin Always watch the fuel level and be careful not If the engine has s topped because of lack of fue l, it is necessary to use the priming pump to bleed the air completely from the fuel circu This engine cons ists of higher precision parts tha n on the conventiona l fuel injection pump and noz zle, so if dirt gets in, it wil cause problems. If there is any dirt stuck to the fu el line, use fuel to wa sh it off c ompletely.

Be careful when opening the air bleed plug at the fuel filter head. The s ystem is still under pressur e and fuel may spurt out. 1. Loosen air ble ed plug (A) at the fuel main f D so o not loosen the pl if it is loosened, ug of the fuel pre-filter head. This it will be impossible to bleed the is at the suction end, air. 2. Loosen wing nut (4) holding lever (3) of pri 3. Push in lever Check that bu (A). bbles come out with the fuel from air bleed plug 4. Coat LT-2A ( pressurized material adhesive compound) on air bleeding plug Specified tigh (A) and then tighten it. .5 - 0.7 kgm ) tening torque: 4.9 - 6.9 Nm (0