. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE NOTICE dirt or oil. 2) If the yellow red element is elements. 4 - 24 If small holes or thin ner parts are found on the e lemen t when i with an electric bulb after cleaning and drying, r eplac e the ele When cleaning the el ement, do not hit it or beat it against som ething. Do not use an eleme nt whose folds or gasket or seal are dama 6. Remove the cl oth or tape cover installe d in Step 3. 7. Check that the re is no dirt or oil stuck t o the seal po rtion of the new element or clean ed element. Wipe o ff any NOTICE The inner element must not be cleaned and used again.
W hen replacin g the outer element, rep lace the inner elemen t at the same time. If the inner elemen t is not installed properly an d the outer ele ment an d cov er areinstalled, there is danger that the outer e lement will be damaged. The seal portion o n imitation parts lacks precision, and allo ws the e ntry of dust, which leads to damage of the engine. Do not use such imitation parts. 8. Push the out installing it to t If the outer ele to the left and r inserted easily 1) Check tha insert it se he air cleaner body.
ment is held and rocked l ightly up and down ight while pushing it in, th e outer elem ent can w piston in dust indicat or (1) overla ps the n the outer diameter immediately afte both