. MAINTENANCE SERVICE PROCEDURE tightening of the filter if any damage or 4 - 77 Bleed the air as follow 7. Add fuel to the fue l tank un til full (to F ULL mark on the 8. 9. Loosen a Loosen w ir bleed ing nut ( plug (C) a 6) holdin t the fuel g lever (5) main filter of priming head (3 pump ( 10. Push in l Check th ever (5) r at bubble epeatedl s come o (C). 11. Tighten a ir bleed plug Tightening torque : 4.9 to 6. 9 Nm (0.5 t o 0.7 kgm , 3.6 to 5 12. Tighten wing nut ( 6) secure ly to lock l ever (5) i n positio Target tightening torque: 1 1.8 Nm (1. 2 kgm, 8. 13. After rep lacing the filter car tridge, sta rt the engine and run it at low idling for 10 minutes.
Check fo r leakag e of fuel f rom the fi lter seal s urface. If any f uel is leaking, check the t cartridge . If there is still fue l leakage, repeat S teps 1 - 4 to remove the filter cartridge, a embedde d foreign material in the pac king surface is fo und, replace it with a new cartridg - 15 to in REMARK When only th e filter ca rtridge is replaced, it is suffficient tha t air bleeding is carried out for the when the fue l piping i s remove d, air blee ding shoul d also b e carried out for the injection pum