Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN HYDRAULIC TANK, REPLACE HYDRAULIC OIL FILTER ELEMENT WARNING 6 ° . Lower ripper (b) on the ground vertically so that the pin is at the lowest position. 4 - 78 EVERY 2000 HOURS SERVI Maintenance fo r every 2 50, 500 a nd 1000 hours service shoul d be carried out at the s The oil is at high t emperatu re immediat ely after the machine has been o perated. Wait for the oil to cool down before changi ng the oil. When r emoving t he oil fille r cap , turn i t slowly t o releas e the internal p ressure, then remove it ca Oil replacem ent amount: 85 lite rs (22.4 6 US g 1.

Park the m achine o n the flat g round, h old it in the following posture suitable for an oil check and then st op the engine. (Sigmadozer) Lower the blad e on the ground so that an gle (a) of its backsid e is Item Dimension Item Dimension Blade (DUAL) Tilt Cylinder length 1,292mm (50.9in) Tilt Cylinde Blade (SINGLE) Brac 1,292mm r length (50.9in) 1,292mm e (50.9in) Ripper (VGR,VMR) Lift Cylinder length 1,543mm (60.8in) Lift Cylinde Ripper (VGR,VMR) Tilt Cylinde 1,543mm r length (60.8in) Tilt Cylinder length 1,607mm (63.3in) 1,607mm r length (63.3in)