TROUBLESHOOTING BEFORE CARRYING OUT TROUBLESHOOTING WHEN CODE IS DISPLAYED Connection table of fuse box a This connection table shows the devices to which each power supply of the fuse box (FB1) supplies power (A switch power supply is a device which supplies power while the starting switch is at the ON position and a constant power supply is a device which supplies power while the starting switch is at the OFF position). a When carrying out troubleshooting related to the electrical system, you should check the fuse box and fus- ible link to see if the power is supplied normally. 20-304 PC130-7 (1) Type of power supply Fuse No.
Fuse capacity Destination of power Switch power supply (Fusible link:
A34) 1 10A Governor and pump controller (Controller power supply) PC-EPC solenoid (Emergency pump drive switch circuit) Swing holding brake solenoid (Swing holding brake release switch circuit) 2 20A Governor and pump controller (Solenoid power supply) 3 10A PPC oil pressure lock solenoid Starting motor cutout relay (For PPC lock) 4 10A Cigarette lighter Windshield washer motor 5 10A Horn 6 10A Lower wiper motor [If equipped] 7 10A Rotary lamp [If equipped] 8 10A Working lamp (Boom and right front) Working lamp (Left front and rear) [If equipped] 9 10A One-touch power maximizing switch circuit 10 10A Fuel priming pump [If equipped] 11 20A Air conditioner unit 12 20A Starting motor cutout relay (For personal code) Monitor panel (Switch power supply) 13 20A Light relay 1 Light relay 2 Panel night light signal circuit 14 10A Heated seat [If equipped] 15 10A Heated seat [If equipped] Travel alarm [If equipped] Constant power supply (Fusible link:
A35) 16 10A DC/DC converter (Power supply to 12-V devices) 17 20A Monitor panel (Constant power supply) 18 10A Starting switch 19 10A Room lamp 20 10A (Spare)