TROUBLESHOOTING INFORMATION IN TROUBLESHOOTING TABLE INFORMATION IN TROUBLESHOOTING TABLE a The following information is summarized in the troubleshooting table and the related electrical circuit dia- gram. Before carrying out troubleshooting, understand that information fully. Related circuit diagram This is a circuit diagram of the part related to troubleshooting. Connector No.: Shows the "Type-Number of pin" and "Color". Branching/Merging point: Shows that there is a branching/merging point in the electric circuit to be checked. Arrow ( ): Roughly shows the location on the machine.
PC130-7 20-403 (1) Trouble Trouble which occurred in the machine Related information Information related to the detected trouble or troubleshooting Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Possible causes of trouble (Given numbers are reference numbers, which do not indicate priority) • Disconnection Connector is connected imperfectly or wiring harness is broken. • Grounding fault Wiring harness which is not connected to chassis ground circuit is in contact with chassis ground circuit.
• Short circuit with power source Wiring harness which is not connected to power source (24-V) circuit is in contact with power source (24-V) circuit. 1) Method of indicating connector No. and handling of T-adapter Insert or connect T-adapter as explained below for troubleshoot- ing, unless otherrwise specified. • If connector No. has no marks of "male" and "female", disconnect connector and insert T-adapters in both male side and female side. • If connector No. has marks of "male" and "female", disconnect connector and connect T-adapter to only male side or female side. 2) Entry order of pin Nos.
and handling of circuit tester leads Connect positive (+) lead and negative (-) lead of circuit tester as explained below for troubleshooting, unless otherwise specified. • Connect positive (+) lead to pin No. or harness entered on front side. • Connect negative (-) lead to pin No. or harness entered on rear side. 2 3 4