TROUBLESHOOTING E-10 E-10 No items of monitor panel light up Circuit diagram related to monitor panel power supply PC130-7 20-421 (1) Trou ble • No items of monitor panel light up. When the starting switch is turned ON, no items of monitor panel light up.
Rela inform ted ation Possible and stan value in n state Cause 1 Defective fuse No.12 Disconnection in wiring harness 2 (Disconnection in wir ing harness or defective contact in connector) causes dard Short circuit with chassis ormal ground in wiring harness 3 (Contact with ground circuit) 4 Defective monitor panel Standard value in normal state/Remarks on troubleshooting Defective fuse No.12 If the fuse is broken, the circuit probably has a grounding fault, etc. (See cause 3.) Disconnection in wiring harness (Disconnection in wir ing harness or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch.
Wiring harness between FB1-12 outlet and J07 Resistance Max. 1 z and P01 (female) (1), (2) Wiring harness between P01 (female) (6), (7) Resistance Max. 1 z and chassis ground (A11) esistance Max. 1 z esistance Max. 1 z Short circuit with chassis ground in wiring harness (Contact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. Between FB1-12 outlet – J07 – P01 (female) Resistance Min. 1 Mz (1), (2) wiring harness and chassis ground esistance Min. 1 Mz Defective monitor panel aPrepare with starting switch OFF.
P01 (female) Starting switch Voltage/Resistance Between (1), (2) and ON 20 – 30 V chassis ground Between (6), (7) and OFF Max. 1 z chassis ground Starting switch Voltage/Resistance ON 20 – 30 V OFF Max. 1 z