Komatsu — TROUBLESHOOTING

TROUBLESHOOTING S-2 (3) Exhaust smoke comes out but engine does not start (Fuel is being injected) General causes why exhaust smoke comes out but engine not start 20-610 PC130-7 (1) Lack of rotating force due to defective electrical system Insufficient supply of fuel Insufficient intake of air Improper selection of fuel and oil Causes Defective, broken valve system (valve, rocker lever, etc.) Defective injection pump (rack, plunger stuck) Worn piston ring, cylinder liner Clogged fuel filter, strainer Clogged feed pump strainer Clogged air cleaner element Defective electrical intake air heater Defective or deteriorated battery Leakage, clogging, air in fuel system Clogged injection nozzle, defective spray Clogged air breather hole in fuel tank cap reporpmI leuf desu Questions Check items Confirm recent repair history Degree of use of machine Operated for long period Suddenly failed to start When engine is cranked, abnormal noise is heard from around cylinder head Engine oil must be added more frequently Non-specified fuel is being used Replacement of filters has not been carried out according to Operation Manual Rust and water are found when fuel tank is drained Dust indicator lamp is red Indicator lamp does not light up Starting motor cranks engine slowly Mud is stuck to fuel tank cap When fuel lever is placed at FULL position, it does not contact stopper When engine is cranked with starting motor, 1) Little fuel comes out even when injection pump piping sleeve nut is loosened 2) No fuel comes out even when fuel filter air bleed plug is loosened There is leakage from fuel piping When exhaust manifold is touched immediately after starting engine, temperature of some cylinders is low When fuel filter is drained, no fuel comes out Troubleshooting Remove head cover and check directly When control rack is pushed, it is found to be heavy, or does not return When compression pressure is measured, it is found to be low When fuel filter, strainer are inspected directly, they are found to be clogged When feed pump strainer is inspected directly, it is found to be clogged When air cleaner element is inspected directly, it is found to be clogged Heater mount does not become warm Either specific gravity of electrolyte or voltage of battery is low When feed pump is operated, there is no response, or operation is too heavy Speed does not change when operation of certain cylinders is stopped When fuel tank cap is inspected directly, it is found to be clogged Remedy Replace Replace Replace Clean Clean Clean Correct Replace Correct Clean Clean