TESTING AND ADJUSTING ADJUSTING ENGINE SPEED SENSOR ADJUSTING ENGINE SPEED SENSOR 4. After finishing adjustment, check that the monitor panel displays the engine speed normally in the "Monitoring mode". a For the operating method, see "Special func- tions of monitor panel". Monitoring code: 010 (Engine speed) a If the engine speed sensor has been removed and installed or its signal contains an error, adjust it according to the following procedure. a Remove engine speed sensor (1) before adjust- ing it and check that its tip is free from steel chips (The engine speed sensor is installed to the right side of the flywheel housing). 1.
Screw in sensor (1) until its tip touches the tooth tip of flywheel ring gear (2). 2 Threads: Gasket sealant (LG-6) 2. Return sensor (1) by the specified angle. a Returning angle of sensor: 1 ± 1/6 turn a After this adjustment, clearance (a) between the sensor tip and gear tooth tip is 1.25 – 1.75 mm. 3. Fixing sensor (1), tighten nut (3). 2 Nut: 49 – 68.6 Nm {5 – 7 kgm} 20-116 PC130-7 (1)