TESTING AND ADJUSTING TESTING AND ADJUSTING FAN BELT TENSION TESTING AND ADJUSTING FAN BELT TENSION ADJUSTING a If the deflection of the belt is abnormal, adjust it according to the following procedure. TESTING 1. Open the engine hood and remove the belt cover from above the alternator. 1. Loosen alternator mounting bolts (1) and (2). 2. Adjust the belt tension by moving alternator (5) with adjustment bolt (4). a Turn the adjusting belt to left, the belt tension tight. 2. Press the intermediate point of the belt between the fan pulley and alternator pulley with a finger and measure deflection (a) of the belt. Force to press belt: Approx. 58.8 N {6 kg} Deflection (a): 6 – 10 mm 3.
Tighten locknut (3) and mounting bolts (2) and (1). a Check breakage of the pulleys, wear of the V-grooves, and contact of the belts and V- grooves. a If a belt is lengthened to the adjustment limit, cut, or cracked, replace it with new one. 4. After finishing adjustment, return the covers. a If a V-belt is replaced, adjust its tension again after 1 operating hour. PC130-7 20-117 (1)