Komatsu — 20-201--.pdf

TESTING AND ADJUSTING TESTING AND ADJUSTING TRACK SHOE TENSION TESTING AND ADJUSTING TRACK SHOE TENSION ADJUSTING a If the track shoe tension is out of the standard range, adjust it according to the following proce- dure. TESTING 1. Running the engine at low idling, move the machine forward by the length of track on ground and stop slowly. 1. When tension is too high 1) Loosen valve (1) gradually to discharge the grease. 2. Place straight bar [1] on the track shoe between the idler and the 1st carrier roller. a As straight bar [1], use an L-shape steel, etc. which will be deflected less.

k Since the valve may jump out because of the high-pressure grease in it, do not loosen it more than 1 turn. a If the grease is not discharged well, drive the machine forward and in reverse slowly. 2) Tighten valve (1). 3. Measure maximum clearance (a) between straight bar [1] and track shoe. Standard maximum clearance (a): 10 – 30 mm 3 Valve: 58.8 – 88.2 Nm {6 – 9 kgm} 3) After finishing adjustment, check again that the track shoe tension is normal according to the above described procedure. 2. When tension is low 1) Add grease through valve (2). a If the track shoe is not tensed well, drive the machine forward and in reverse slowly.

2) After finishing adjustment, check again that the track shoe tension is normal according to the above described procedure. 20-120 PC130-7 (1)