Komatsu — 20-201--.pdf

TESTING AND ADJUSTING MEASURING CLEARANCE OF SWING CIRCLE BEARING MEASURING CLEARANCE OF SWING CIRCLE BEARING a Measuring instrument for clearance of swing cir- cle bearing a When measuring the clearance of the swing cir- cle bearing on the actual machine, observe the following procedure. k While measuring, do not put your hands or foot under the undercarriage. 4. Set the arm at almost a right angle to the ground and lower the boom until the track shoe at the front side of the machine is floated. a At this time, the front end of the upper struc- ture rises and the rear end lowers. 1.

Fix dial gauge G to outer race (1) or inner race (2) of the swing circle and apply the probe to the end face of inner race (2) or outer race (1) on the opposite side. a Set dial gauge G on the front or at rear side of the machine 5. Under this condition, read dial gauge G . a Dial gauge G indicates the clearance of the bearing. 2. Set the work equipment in the maximum reach posture and set the bucket tip to the height of the revolving frame bottom. a At this time, the front end of the upper struc- ture lowers and the rear end rises. 6. Return the machine to the posture of step 2 and check that dial gauge G indicates 0 again. a If dial gauge G does not indicate 0, repeat steps 3 – 5 . 3.

Set the dial gauge G to the 0 point. 7. After finishing measurement, remove the mea- suring instruments and return the removed parts. PC130-7 20-119 (1) Symbol Part No. Part name G Commercially available Dial gauge