TESTING AND ADJUSTING TESTING AND ADJUSTING OIL PRESSURE IN WORK EQUIPMENT, SWING, AND TRAVEL CIRCUITS TESTING AND ADJUSTING OIL PRESSURE IN WORK EQUIPMENT, SWING, AND TRAVEL CIRCUITS a Testing and adjusting instruments for oil pressure in work equipment, swing, and travel circuits 2) Install nipple H2 and connect it to oil pres- sure gauge [1] of hydraulic tester H1 . a Use the oil pressure gauges of 58.8 MPa {600 kg/cm 2 }. a The oil pressure in work equipment, swing, and travel circuits (pump discharge pressure) can be checked with monitoring function [02] of the monitor panel. Monitoring code: 011, 012 (Pump discharge pressure) a The pump discharge pressure is displayed in 1 kg/cm 2 .
3) Run the engine and heighten the hydraulic oil temperature to 45 – 55°C. MEASURING 1. Preparation work k Lower the work equipment to the ground and stop the engine. Operate the control levers several times to release the residual pressure in the piping, and then loosen the oil filler cap of the hydraulic tank slowly to release the internal pressure of the hydrau- lic tank. 1) Remove the top cover of the control valve, and then remove pump pressure pickup plug (1) from the top of the control valve. 2. Measuring unload pressure 1) Start the engine. 2) Run the engine at high idling and set all the control levers in neutral and measure the oil pressure.
a The pressure measured when the unload valve is unloaded is indicated. 20-122 PC130-7 (1) Symbol Part No. Part name H 1 799-101-5002 Hydraulic tester 790-261-1203 Digital hydraulic tester 2 799-101-5220 Nipple (10 x 1.25 mm) 07002-11023 O-ring