TESTING AND ADJUSTING TESTING AND ADJUSTING OIL PRESSURE IN PUMP PC CONTROL CIRCUIT ADJUSTING Adjusting PC valve a If either of the following phenomena occurs and the PC valve seems to be defective, adjust PC valve (3) according to the procedure shown below. As the working load increases, the engine speed lowers remarkably. The engine speed is normal but the work equipment speed is low. a The figure shows the hydraulic pump seen from the front side of the machine. 5. While running the engine at high idling, measure the pump discharge pressure and PC valve out- put pressure (servo piston inlet pressure) simul- taneously. Working mode: A Swing lock switch:
LOCK (2-stage relief valve is turned ON and relief pressure is set high) Work equipment, swing, and travel circuits: Relieve arm circuit by moving arm IN. a Method of judgment: If the pump discharge pressure and PC valve output pressure (servo piston output pres- sure) are in the following ratio, they are nor- mal. 1. Loosen hose fixing (4). 2. Fixing sleeve (5), loosen locknut (6). 3. Turn sleeve (5) to the right or left to adjust the pump absorption torque. a If the sleeve is turned to the right, the pump absorption torque increases. turned to the left, the pump absorption torque decreases. a Limit the turning angle of the sleeve to the following range. Right turning: Max.
1 turn (360°) Left turning: Max. 1/2 turn (180°) a Change of servo piston stroke per turn of sleeve: 1.5 mm a If the PC valve or the servo piston is abnor- mal, the PC valve output pressure (servo pis- ton inlet pressure) is "the same as the pump discharge pressure" or "almost 0". 6. After finishing measurement, remove the mea- suring instruments and return the removed parts. 4. Fixing sleeve (5), tighten locknut (6). 3 Locknut: 88 – 113 Nm {9 – 11.5 kgm} PC130-7 20-127 (1) Measured oil pressure Ratio of oil pressure Pump discharge pressure 1 PC valve output pressure (Servo piston inlet pressure) Approx. 3/5