Komatsu — 20-201--.pdf

TESTING AND ADJUSTING BLEEDING AIR FROM EACH PART 3. Bleeding air from cylinder a If a cylinder was replaced, bleed air from it before connecting the work equipment. In particular, the boom cylinder does not move to the lowering stroke end, if it is installed to the work equipment. 1) Run the engine at low idling for about 5 min- utes. 2) Running the engine at low idling, raise and lower the boom 4 – 5 times. a Stop the piston rod about 100 mm before each stroke end. Do not relieve the oil. 3) Running the engine at high idling, perform step 2). 4) Running the engine at low idling, move the piston rod to the stroke end and relieve the oil.

5) Bleed air from the arm cylinder and bucket cylinder according to steps 2) – 4). 5. Bleeding air from travel motor 1) Remove the travel motor cover and run the engine at low idling. 2) Loosen drain hose (4) and check that oil oozes out, and then tighten the drain hose. 4. Bleeding air from swing motor 1) Run the engine at low idling. 2) Loosen air bleeding plug (3) and check that the oil oozes out, and then tighten the air bleeding plug. 3) Running the engine at low idling and using the work equipment, raise the track shoe on either side. 3 Air bleeding plug: 25.5 – 34.3 Nm {2.5 – 3.5 kgm} 3) If the oil does not oozes out, remove air bleeding plug (3) and fill the pump case with oil.

4) Running the engine at low idling, run the raised track shoe idle slowly for about 2 min- utes. a Run the track shoe forward and in reverse as evenly as possible. a Run the track shoe on the opposite side idle similarly. 4) Run the engine at low idling and swing slowly 2 turns or more in each direction. 20-144 PC130-7 (1)