TESTING AND ADJUSTING BLEEDING AIR FROM EACH PART BLEEDING AIR FROM EACH PART Note: Bleed air from the swing motor and travel motor only when the oil in the motor cases is drained. 1. Bleeding air from hydraulic pump 1) Open the pump room cover, loosen bleeder (1), and check that oil flows out. 2) If the oil does not flow out, disconnect drain hose (2) and fill the pump case with oil through the drain port. a Fix the drain hose adapter to a place higher than the oil level in the hydraulic tank. a Fill the pump case with oil until oil con- taining no bubbles flows out of the bleeder. 3) After oil containing no bubbles flows out of bleeder (1), tighten the bleeder. 3 Air bleeder:
7.8 – 9.8 Nm {0.8 – 1.0 kgm} a If the drain hose has been disconnected, connect it after tightening the bleeder. 2. Starting engine When running the engine after performing step 1, keep its speed at low idling for 10 minutes. a If the engine coolant temperature is low and the automatic warm-up operation is started, stop the engine temporarily and reset the automatic warm-up operation with the fuel control dial (Set the starting switch in the ON position and hold the fuel control dial in the MAX position for 3 seconds, and the auto- matic warm-up operation is reset).
PC130-7 20-143 (1) Air bleeding item Contents of work Air bleeding procedure 1 2 3 4 5 6 Bleeding air from hydraulic pump Starting engine Bleeding air from cylinder Bleeding air from swing motor Bleeding air from travel motor Checking oil level and starting operation • Replacing hydraulic oil • Cleaning strainer q q q q (See note) q (See note) q • Replacing return filter element q q • Replacing and repairing hydraulic pump • Removing suction piping q q q q • Replacing and repairing control valve • Removing control valve piping q q q • Replacing and repairing cylinder • Removing cylinder piping q q q • Replacing and repairing swing motor • Removing swing motor piping q q q • Replacing and repairing travel motor • Removing travel motor piping q q q • Replacing and repairing swivel joint • Removing swivel joint piping q q