TESTING AND ADJUSTING PREPARATION WORK FOR TROUBLESHOOTING FOR ELECTRIC SYSTEM PREPARATION WORK FOR TROUBLESHOOTING FOR ELECTRIC SYSTEM 2. Governor and pump controller a The governor and pump controller is installed in the cover at the rear of the operator's seat. 1) Remove the 3 mounting bolts and cover (3). a When carrying out troubleshooting for an electric circuit related to the monitor panel and governor and pump controller, expose the related connec- tors according to the following procedure. 1. Monitor panel 1) Remove cover (1) a The cover is fixed with 2 clips at the top and bottom. Just pull it up to remove it.
a If the daylight sensor of the air condi- tioner is installed, disconnect connector P15 on the back side of the cover. 2) Insert or connect testing T-adapters in or to connectors C01, C02, and C03 of governor and pump controller (4). a Since the connectors are secured with screws, loosen those screws before dis- connecting. a When connecting the connectors again, tighten their screws to the specified torque. 3 Screw: 2.82 Nm {0.288 kgm} 2) Remove the 3 mounting screws, and then remove monitor panel (2) from the mount. a Take care not to drop the mounting screws into the console. 3) Insert or connect testing T-adapters in or to connectors P01 and P02 of the monitor panel.
a Connector P70 clamped near the above connectors is not used. 20-166 PC130-7 (1)