Komatsu — 20-201--.pdf

TESTING AND ADJUSTING SPECIAL FUNCTIONS OF MONITOR PANEL 9. Special functions of engine oil replacement monitor 1) Ordinary display of engine oil replacement monitor If the rest of time before the set engine oil replacement time is 10 hours or shorter, engine oil replacement monitor (10) lights up and display the elapsed time in service meter section for 20 seconds each time the starting switch is turned ON. 4) Function of demonstration mode If the demonstration mode is selected, you can perform demonstration of the oil mainte- nance function when teaching the operation to a customer. The functions and display of the demonstra- tion mode are as follows. 1.

The internally set interval is recognized as 250 hours and the elapsed time is rec- ognized as 240 hours. 2. When the starting switch is turned ON after the demonstration mode is set, the ordinary display is repeated up to 3 times (number of the times of turning the start- ing switch ON). 3. After the demonstration is finished, reset- ting of maintenance setting [0] is recog- nized. a When the demonstration is repeated 3 times, resetting of maintenance setting is recognized. If setting is necessary at this time, see "Function of selecting mainte- nance period".

2) Checking elapsed time To check the elapsed time while engine oil replacement monitor (10) is OFF, turn the starting switch OFF and press set switch (5) and then turn the starting switch ON and keep holding set switch (5). 3) Clearing elapsed time To clear the elapsed time after replacing the engine oil, hold set switch (5) for 3 seconds while the elapsed time is displayed. a If the above operation is performed, the elapsed time in the monitor panel is set to 0 hour. PC130-7 20-165 (1)