Komatsu — 20-201--.pdf

3. Hydraulic drift of work equipment Hydraulic oil temperature: 45 55 °C PC130-7 20-171 (1) Point (Service limit value) 2.84–3.43MPa {29–35kg/cm2} 33.3–37.0MPa {343–378kg/cm2} 36.3–39.2MPa {370–400kg/cm2} 1.96–3.7MPa {21–38kg/cm2} 2.1–2.3MPa {21.5–23.5kg/cm2} 28.9–32.9MPa {295–335kg/cm2} 36.3–39.2MPa {370–400kg/cm2} (1):(3)=1:0.5 (4) 60kg/cm2 Control basic pressure (3) 600kg/cm2 Servo inlet pressure (2) 600kg/cm2 LS pressure (1) 600kg/cm2 Pump pressure Hydraulic oil temperature: 45 – 55 °C 4. Oil pressure Unit MPa {kg/cm2} Measured item (Tested part) Control basic pressure (Self-reducing pressure valve) Pump relief pressure (Main relief valve:

Low pressure) Pump relief pressure (Main relief valve: High pressure) LS differential pressure (LS valve: Neutral) LS differential pressure (LS valve: Operated) Right Left Right front Right rear Left front Left rear PC control pressure (PC valve) Swing relief pressure (Motor safety valve) Travel relief pressure (Main relief valve) (Motor safety valve) Condition Operation of work equipment All levers in neutral Arm DUMP relief Arm DUMP relief All levers in neutral Idle travel (With shoe raised) Swing lock (Switch: LOCK) Travel lock (With sprocket fixed) Swing lock (Switch: LOCK) One-touch power max.

switch OFF OFF ON OFF OFF OFF OFF OFF Auto decelerator OFF OFF OFF OFF OFF OFF OFF OFF Working mode A A A A A A A A Fuel control dial Full (MAX) Full (MAX) Full (MAX) Full (MAX) Full (MAX) Full (MAX) Full (MAX) Full (MAX) No. 1 2 3 4 5 6 Judgment Good/Bad Measured value Standard value Service limit value Max. 700 Standard value for new machine Max. 460 Unit mm Measured item Lowering distance of bucket tip (in 15 min) Condition Position of work equipment Arm top and boom foot on level, rated load on bucket Working mode Engine stopped Fuel control dial No. 1