Komatsu — 3) Action to take after removing connectors

TROUBLESHOOTING POINTS TO REMEMBER WHEN CARRYING OUT MAINTENANCE 2) Removing, installing, and drying connectors and wiring harnesses Disconnecting connectors 1) Hold the connectors when disconnecting. When disconnecting the connectors, hold the connectors and not the wires. For con- nectors held by a screw, loosen the screw fully, then hold the male and female connec- tors in each hand and pull apart. For con- nectors which have a lock stopper, press down the stopper with your thumb and pull the connectors apart. a Never pull with one hand. 2) When removing from clips When removing a connector from a clip, pull the connector in a parallel direction to the clip.

a If the connector is twisted up and down or to the left or right, the housing may break. 3) Action to take after removing connectors After removing any connector, cover it with a vinyl bag to prevent any dust, dirt, oil, or water from getting in the connector portion. a If the machine is left disassembled for a long time, it is particularly easy for im- proper contact to occur, so always cover the connector. 20-206 PC130-7 (1)