TROUBLESHOOTING POINTS TO REMEMBER WHEN CARRYING OUT MAINTENANCE Connecting connectors 1) Check the connector visually. 1) Check that there is no oil, dirt, or water stuck to the connector pins (mating por- tion). 2) Check that there is no deformation, defective contact, corrosion, or damage to the connector pins. 3) Check that there is no damage or break- age to the outside of the connector. a If there is any oil, water, or dirt stuck to the connector, wipe it off with a dry cloth. If any water has got inside the connec- tor, warm the inside of the wiring with a dryer, but be careful not to make it too hot as this will cause short circuits.
a If there is any damage or breakage, re- place the connector. 2) Fix the connector securely. Align the position of the connector correctly, then insert it securely. For connectors with lock stopper, push in the connector until the stopper clicks into position. 3) Correct any protrusion of the boot and any misalignment of the wiring harness For connectors fitted with boots, correct any protrusion of the boot. In addition, if the wir- ing harness is misaligned, or the clamp is out of position, adjust it to its correct posi- tion. a If the connector cannot be corrected easily, remove the clamp and adjust the position.
4) If the connector clamp has been removed, be sure to return it to its original position. Check also that there are no loose clamps. Connecting connectors (DT type connector) Since the DT 8-pole and 12-pole DT type con- nectors have 2 latches respectively, push them in until they click 2 times. 1. Male connector, 2. Female connector Normal locking state (Horizontal): a , b , d Incomplete locking state (Diagonal): c PC130-7 20-207 (1)