TROUBLESHOOTING POINTS TO REMEMBER WHEN CARRYING OUT MAINTENANCE Drying wiring harness If there is any oil or dirt on the wiring harness, wipe it off with a dry cloth. Avoid washing it in water or using steam. If the connector must be washed in water, do not use high-pressure water or steam directly on the wiring harness. If water gets directly on the connector, do as fol- lows. 1) Disconnect the connector and wipe off the water with a dry cloth. a If the connector is blown dry with com- pressed air, there is the risk that oil in the air may cause defective contact, so re- move all oil and water from the com- pressed air before blowing with air.
2) Dry the inside of the connector with a dryer. If water gets inside the connector, use a dryer to dry the connector. a Hot air from the dryer can be used, but regulate the time that the hot air is used in order not to make the connector or re- lated parts too hot, as this will cause de- formation or damage to the connector. 3) Carry out a continuity test on the connector. After drying, leave the wiring harness dis- connected and carry out a continuity test to check for any short circuits between pins caused by water. a After completely drying the connector, blow it with contact restorer and reas- semble. 20-208 PC130-7 (1)